Removal And Installation Of Komtrax Terminal Assembly - Komatsu PC200-8M0 Shop Manual

SEN06149-00
Removal and installation of
KOMTRAX terminal assembly
k
Park the machine on a level ground, lower
the work equipment to the ground, and
stop the engine.
k
Disconnect the cable from the negative (–)
terminal of the battery.
a Note connector numbers and installed posi-
tions before disconnecting wiring and hoses.
a The position of the KOMTRAX terminal is
shown below.
C: KOMTRAX terminal
q
Removal
1. Remove box (1) (five bolts).
a Disconnect the hose located under box
(1).
2. Remove box (2) (three bolts).
a Be careful about connectors (3) and (4)
located behind box (2) (for machines
equipped with 12 V power socket).
q Connector (3): 12 V power socket
intermediate harness (M13A)
q Connector (4): 12 V power socket
intermediate harness (M13B)
3. Remove cover (5) (three bolts).
8
50-800

Removal and installation of KOMTRAX terminal assembly

4. Remove cover (6) (seven bolts).
a Be careful about connector (7) located
1
behind cover (6).
Connector (7): Cigarette lighter (M04)
q
5. Disconnect connectors (8) to (11).
q Connector (8): Communication antenna
(GPS)
q Connector (9): Machine main harness
(CK01).
q Connector (10): Machine main harness
(CK02).
Connector (11): Communication antenna
q
6. Remove KOMTRAX terminal (C) (four bolts).
Installation
Perform installation in the reverse order to
q
removal.
800 Electrical system
PC200, 200LC, 220, 220LC-8M0