Removal And Installation Of Operator's Cab Assembly - Komatsu PC200-8M0 Shop Manual

Table of Contents

Advertisement

SEN06148-01
Removal and installation of
operator's cab assembly
Removal
k
Disconnect the cable from the negative (–)
terminal of the battery.
1.
Remove front window (1).
2.
Remove step plate (2).
3.
Remove floor mat (3).
4.
Refer to "Removal and installation of monitor
assembly", and remove monitor assembly (4).
5.
Remove covers (5) and (6).
6.
Remove cover and duct assembly (7).
7.
Insert key (8), turn it right, and open the out-
side-air filter cover.
8.
Remove outside-air filter (9).
2
50-700

Removal and installation of operator's cab assembly

9.
Remove rear covers (10) to (13).
10. Remove duct (14).
11. Remove cover (15).
a Disconnect connector H15 fixed on the
back from the clip.
12. Remove plate (16).
13. Remove plate (17).
14. Remove lock pin (18) and remove duct (19).
PC200, 200LC, 220, 220LC-8M0
700 Cab and its attachments

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pc200lc-8m0Pc220-8m0Pc220lc-8m0

Table of Contents