Komatsu PC200-8M0 Shop Manual page 1012

SEN06143-00
66. Disconnect engine ground (82).
67. Remove 4 engine mounting bolts (83).
a The nut is not welded except at the engine
ground point. Due to that reason firstly fix
nut locking tool (plate) A8 with bolt (B) to
restrict nut (N) from turning, then remove
engine mounting bolt (83).
50
50-200
Removal and installation of engine and hydraulic pump as-
68. Lift out engine and hydraulic pump assembly
(84).
a Lift it at the 3 points, i.e. 2 points at the
[*10]
engine and 1 point at the hydraulic pump.
Recommended lifting tool A9 (Refer to the
special tool list) is proposed from Cum-
mins.
a Before removing the assembly, make sure
that all the necessary wiring and piping
are disconnected.
4
Engine and hydraulic pump assembly:
200 Engine and cooling system
PC200, 200LC, 220, 220LC-8M0
800 kg