Removal And Installation Of Machine Monitor Assembly - Komatsu PC200-8M0 Shop Manual

SEN06149-00
Removal and installation of
machine monitor assembly
k
Park the machine on a level ground, lower
the work equipment to the ground, and
stop the engine.
k
Disconnect the cable from the negative (–)
terminal of the battery.
a Note connector numbers and installed posi-
tions before disconnecting wirings and hoses.
Removal
1. Pull up front window assembly (1) to the ceiling
and lock it.
a Check that the front window is securely
locked.
2. Remove front lower window (2).
3. Remove rubber panel (3) (two bolts).
2
50-800

Removal and installation of machine monitor assembly

4. Remove three mounting screws of cover (4).
a One of the three screws is covered with
1
cap (5).
5. Remove connector (6) and then remove cover
(4).
a Connector (6): Sunlight sensor (P31)
6. Remove duct (10) (one bolt).
800 Electrical system
PC200, 200LC, 220, 220LC-8M0