ABB Relion 670 Series Applications Manual page 457

1MRK 511 358-UUS A
18.2.2 Horizontal communication via GOOSE for interlocking
GOOSEINTLKRCV
Table 44: GOOSEINTLKRCV Non group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
18.2.3 Setting guidelines
There are two settings related to the IEC 61850–8–1 protocol:
Operation User can set IEC 61850 communication to Enabled or Disabled .
GOOSE has to be set to the Ethernet link where GOOSE traffic shall be send and received.
18.2.4 Generic communication function for Single Point indication
SPGAPC, SP16GAPC
18.2.4.1 Application
Generic communication function for Measured Value (SPGAPC) function is used to send one single
logical output to other systems or equipment in the substation. It has one visible input, that
should be connected in ACT tool.
18.2.4.2 Setting guidelines
There are no settings available for the user for SPGAPC. However, PCM600 must be used to get the
signals sent by SPGAPC.
18.2.5 Generic communication function for Measured Value MVGAPC
18.2.5.1 Application
Generic communication function for Measured Value MVGAPC function is used to send the
instantaneous value of an analog signal to other systems or equipment in the substation. It can
also be used inside the same IED, to attach a RANGE aspect to an analog value and to permit
measurement supervision on that value.
18.2.5.2 Setting guidelines
The settings available for Generic communication function for Measured Value (MVGAPC) function
allows the user to choose a deadband and a zero deadband for the monitored signal. Values within
the zero deadband are considered as zero.
Application manual
Unit Step Default
- - Disabled
Station communication
Description
Operation Disabled/Enabled
Section 18
SEMOD173197-1 v2
PID-415-SETTINGS v5
SEMOD55317-5 v6
SEMOD55999-1 v4
SEMOD55350-5 v6
SEMOD55376-5 v4
SEMOD55402-1 v3
SEMOD55872-5 v9
SEMOD55424-5 v5
451