®
ABB i-bus
KNX
Parameters
7.5.4
Control value after ETS download
Options:
This parameter specifies which control value is to apply after a download until the controller has calculated
a new control value.
In the actuator mode, the value specified here applies until a new control value has been received via
the bus.
•
Unchanged: The same control value as before the download applies.
•
Select: A control value can be specified. This control value then applies until a new control value
is calculated/a new setpoint is received via the bus. The Control value dependent parameter
is displayed.
7.5.4.1
—
Dependent parameter
Control value
Options:
This parameter is used to specify the control value that is to apply after bus voltage recovery until a new
setpoint is received.
68 2CDC508220D0211 Rev. A | VC/S 4.x.1
Unchanged
Select
0...100 %