Access To I-Bus ® Tool - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Parameters
7.2.4.1 —
Dependent parameter
Send
Options:
7.2.4.2 —
Dependent parameter
Sending cycle time
Options:
The time interval at which the In operation group object cyclically sends a telegram is set here.
After bus voltage recovery, the group object sends its value after the sending and switching delay set.
7.2.5 Access to i-bus
Options:
This parameter is used to restrict or forbid completely access by the ABB i-bus
selected, access by the i-bus
be changed by the i-bus
functions without restriction; values can be displayed and changed (see chapter 4.4
bus®
42 2CDC508220D0211 Rev. A | VC/S 4.x.1
Value 0
Value 1
00:00:01...00:01:00...18:12:15 hh:mm:ss
Note
®
Tool
Deactivated
Value display only
Full access
®
Tool is completely disabled. If Value display only is selected, no values can
®
Tool; only the status is displayed. If Full access is selected, the i-bus
Tool).
®
Tool. If Deactivated is
®
Tool
Integration into the i-