Step 1: Unpack And Inspect The Analyzer - GE Sievers 900 Series Operation And Maintenance Manual

Step 1: Unpack and Inspect the Analyzer

Open the shipping boxes and verify that they contain the following:
1. Sievers 900 On-Line TOC Analyzer
2. Operation and Maintenance Manual
3. Validation Support Package (VSP) Volume 1
4. Accessory package containing:
• 1/4" sample inlet tubing with in-line filter (for sampling through IOS System)
• 25/32" clamp for 1/4" sample inlet tubing
• 1/16"-OD Teflon tubing with 1/4" Valco nut and ferrule (for container sampling, also
referred to as a "sipper tube")
• Replacement pump tubing assembly
• 3/4" OD tubing for waste line (for on-line configuration)
• 1/8" OD tubing with 5/16" SwageLok fitting for waste line (for grab configuration)
• 3/32" Allen wrench
• 1/4" open-end wrench
• 9/16" open-end wrench
• Water bottle (250 mL) with nozzle for filling DI water reservoir
• USB flash memory drive
• pH paper
• Stainless steel metric tubing converter (1/4-in-to-6-mm tube)
• Two PVC conduit connectors ("strain relief" hubs) for conduit wiring
(for 900 On-Line Analyzer only)
• Sealing washers for PVC conduit connectors (for 900 On-Line Analyzer only)
• Terminal ring for AC conduit ground wire, 16-14 AWG
(for 900 On-Line Analyzer only)
• 1/8" OD tubing with 1/8" Swagelok fitting for waste line, approximately 12" long
• 10-mL graduated cylinder
GE Analytical Instruments ©2009 60 of 236 DLM 90488-01 Rev. A