Warnings And Error Messages - GE Sievers 900 Series Operation And Maintenance Manual

2. Press the Warnings/Errors button.
3. Use the scroll buttons to browse the warnings and errors.
4. Press the Print button to print the list.
You also can print or export a full list of warnings and errors that includes the time each event
occurred, even after you have removed items from the Warnings/Errors list. To do so, follow these
steps:
1. Select the Maintenance tab.
2. Press the Advanced button.
3. Press the Warn/Error Out button.
4. Press either the Print History or Export History button.
If you select Export History, you will be prompted to select the port for export. Press either
Serial or USB to export the list of warnings and errors.
A complete list of warnings and errors is shown below.

Warnings and Error Messages

2 - Analog Warning
Message: "An analog error was detected. Turn power off and on to reset. Contact GE if the error
persists."
Explanation: This warning generally displays when the temperature or conductivity for the
measurement is out of range. Turn the Analyzer off and on and restart analysis. If the warning
persists, contact Technical Support.
3 - Acid Warning
Message: "The estimated amount of acid is less than 10%. Confirm the amount is low. Order a new
acid container."
Explanation: Based on the flow rate and history of usage, the Analyzer estimates that only 10% of
the acid reagent is remaining. Order a new acid container from GE now to avoid down time when
the acid is exhausted.
4 - Oxid Warning
Message: "The estimated amount of oxidizer is less than 10%. Confirm the amount is low. Order a
new oxidizer container."
Explanation: Based on the flow rate and history of usage, the Analyzer estimates that only 10% of
the oxidizer reagent is remaining. Order a new acid container from GE now to avoid down time
when the oxidizer is exhausted.
GE Analytical Instruments ©2009 196 of 236 DLM 90488-01 Rev. A