Dell C9000 Series Reference Manual page 191

Version
8.3.11.1
8.2.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
7.4.1.0
E-Series
Usage Information When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address, timeout (in
seconds) (default is 5), a probe count (default is 3), minimum TTL (default is 1),
maximum TTL (default is 30), and port number (default is 33434). To keep the default
setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum hop
count (default is 64).
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1)
[OK]
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to www.force10networks.com (10.11.84.18),
30 hops max, 40 byte packets
-----------------------------------------------
TTL Hostname
1
2
001.000 ms 001.000 ms
3
000.000 ms 000.000 ms
4
000.000 ms
Dell#
Example (IPv6)
Dell#traceroute 100::1
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to 100::1, 64 hops max, 60 byte packets
-----------------------------------------------
Hops Hostname Probe1
1
Dell#traceroute 3ffe:501:ffff:100:201:e8ff:fe00:4c8b
Description
Introduced on the Z9000.
Introduced on the E-Series ExaScale with IPv6.
Introduced on the E-Series ExaScale (IPv4 only).
Introduced VRF.
Added support for the S-Series.
Introduced on the C-Series.
Added support for IPv6 address on the E-Series.
Original command.
Probe1
10.11.199.190 001.000 ms 001.000 ms 002.000 ms
gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms
fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms
www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms
100::1 000.000 ms 000.000 ms 000.000 ms
Probe2 Probe3
Probe2 Probe3
Control and Monitoring 191