Seq - Dell C9000 Series Reference Manual

seq

To a deny or permit filter in a MAC access list while creating the filter, assign a sequence number.
C9000 Series
Syntax
seq sequence-number {deny | permit} {any | mac-source-address
[mac-source-address-mask]} [count [byte]] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
sequence-
number
deny
permit
any
mac-source-
address
mac-source-
address-mask
count
byte
log
threshold-in msgs
count
interval minutes
monitor
Enter a number from 0 to 65535.
Enter the keyword deny to configure a filter to drop packets
meeting this condition.
Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
Enter the keyword any to filter all packets.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
(OPTIONAL) Specify which bits in the MAC address must match.
If no mask is specified, a mask of 00:00:00:00:00:00 is applied
(in other words, the filter allows only MAC addresses that
match).
(OPTIONAL) Enter the keyword count to count packets the filter
processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL) Enter the keyword log to include ACL messages in
the log.
(OPTIONAL) Enter the threshold-in-msgs keyword followed
by a value to indicate the maximum number of ACL logs that
can be generated, exceeding which the generation of ACL logs
is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword interval followed by the time
period in minutes at which ACL logs must be generated. The
threshold range is from 1 to 10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
Access Control Lists (ACL) 340