Power Inline - Dell C9000 Series Reference Manual

Version
9.10(0.0)
9.9(0.0)
Usage Information Configure a global threshold limit for the Power over Ethernet (PoE) power budget for a
specified port extender. A default power threshold value of 99% is configured when
there is no threshold value configured.
Use this command in Configuration Terminal Batch mode to configure the threshold
limit for the PoE power budget in a dual-homing setup.
Example
Dell(conf)#power budget global-threshold pe 1 stack-unit 0 99
Dell#show power detail pe 0 stack-unit 0
Unit
Inline
Power
Consumed Remaining
(Watts)
--------- ---------- --------- --------- --------- --------- ---------
--------------
0/0
0
Related Command show power detail

power inline

Enable inline power and configure maximum power allocation with priority for the powered device
connected to an interface.
C9000 Series
Syntax
power inline {[max_milliwatts ]| priority {critical | high | low}}
To disable a device that has been enabled for PoE power supply, use the no power
inline command.
Parameters
max_milliwatts
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Total System
Inline
Power Power
Power
Available Consumed Consumed
(Watts) (Watts)
(Watts)
1000 150
841
(OPTIONAL) Specify the maximum amount of inline power
allocation to a powered device connected to the interface.
Range is 440–30000 milliwatts (mWs). The default value is
30000 mWs.
NOTE:
in Static mode.
Redundancy Inline
Power Power
Threshold
(Watts) (%)
0 99
The max_milliwatt configuration is effective only
Inline Inline
Power Power
Available Allocated
(Watts) (Watts)
841 0
Port Extenders (PE) 1752