Ip Domain-Lookup - Dell S4810 Reference Manual

Usage To configure a list of possible domain names, configure the ip domain-list
Information
command up to six times.
If you configure both the ip domain-name and ip domain-list commands,
the software tries to resolve the name using the ip domain-name command. If
the name is not resolved, the software goes through the list of names configured
with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
•
•
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related ip domain-name
Commands

ip domain-lookup

To address resolution (that is, DNS), enable dynamic host-name.
S4810
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
IPv4 Routing
specify a domain name server with the ip name-server command
enable DNS with the ip domain-lookup command
— specifies a DNS server.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
851