Uart1 Scratch Pad Register (U1Scr - 0Xe001 001C); Uart1 Auto-Baud Control Register (U1Acr - 0Xe001 0020); User Manual - Philips LPC2101 User Manual

Philips Semiconductors
Volume 1
Table 113: UART1 Modem Status Register (U1MSR - address 0xE001 0018) bit description
Bit Symbol Value Description
0 Delta CTS
0
1
1 Delta DSR
0
1
2 Trailing Edge RI
0
1
3 Delta DCD
0
1
4 CTS
5 DSR
6 RI
7 DCD

10.3.13 UART1 Scratch Pad Register (U1SCR - 0xE001 001C)

The U1SCR has no effect on the UART1 operation. This register can be written and/or
read at user's discretion. There is no provision in the interrupt interface that would indicate
to the host that a read or write of the U1SCR has occurred.
Table 114: UART1 Scratch Pad Register (U1SCR - address 0xE001 0014) bit description
Bit Symbol
7:0 Pad

10.3.14 UART1 Auto-baud Control Register (U1ACR - 0xE001 0020)

The UART1 Auto-baud Control Register (U1ACR) controls the process of measuring the
incoming clock/data rate for the baud rate generation and can be read and written at
user's discretion.
Table 115: Auto-baud Control Register (U1ACR - 0xE001 0020) bit description
Bit
0

User manual

Set upon state change of input CTS. Cleared on an U1MSR read.
No change detected on modem input, CTS.
State change detected on modem input, CTS.
Set upon state change of input DSR. Cleared on an U1MSR read.
No change detected on modem input, DSR.
State change detected on modem input, DSR.
Set upon LOW to HIGH transition of input RI. Cleared on an U1MSR read.
No change detected on modem input, RI.
LOW-to-HIGH transition detected on RI.
Set upon state change of input DCD. Cleared on an U1MSR read.
No change detected on modem input, DCD.
State change detected on modem input, DCD.
Clear To Send State. Complement of input signal CTS. This bit is connected
to U1MCR[1] in modem loopback mode.
Data Set Ready State. Complement of input signal DSR. This bit is connected
to U1MCR[0] in modem loopback mode.
Ring Indicator State. Complement of input RI. This bit is connected to
U1MCR[2] in modem loopback mode.
Data Carrier Detect State. Complement of input DCD. This bit is connected to
U1MCR[3] in modem loopback mode.
Description
A readable, writable byte.
Symbol Value Description
Start This bit is automatically cleared after auto-baud
completion.
0 Auto-baud stop (auto-baud is not running).
1 Auto-baud start (auto-baud is running).Auto-baud run
bit. This bit is automatically cleared after auto-baud
completion.
Rev. 01 — 12 January 2006
UM10161
Chapter 10: UART1
Reset value
0
0
0
0
0
0
0
0
Reset value
0x00
Reset value
0
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
113