Ipv6 Netstream Export Source - HP MSR1003-8S Command Reference Manual

Predefined user roles
network-admin
Parameters
rate: Specifies the maximum number of packets to be exported per second. The value range is 1 to 1000.
Examples
# Allow a maximum of 10 packets to be exported per second.
<Sysname> system-view
[Sysname] ipv6 netstream export rate 10

ipv6 netstream export source

Use ipv6 netstream export source to specify the source interface for data packets sent to the NetStream
servers. The IPv6 address of the interface is used as the source IPv6 address of the data packets.
Use undo ipv6 netstream export source to remove the configuration.
Syntax
ipv6 netstream export source interface interface-type interface-number
undo ipv6 netstream export source
Default
No source interface is specified for IPv6 NetStream data packets. The packets take the primary IPv6
address of the output interface as the source IPv6 address.
Views
System view, IPv6 NetStream aggregation mode view
Parameters
interface-type interface-number: Specifies a source interface by its type and number for the IPv6
NetStream data export.
Usage guidelines
You can configure different source interfaces in different IPv6 NetStream aggregation mode views.
If no source interface is configured in IPv6 NetStream aggregation mode view, the source interface in
system view applies.
HP recommends that you connect the management Ethernet interface to a NetStream server, and
configure the interface as the source interface.
Examples
# In system view, specify GigabitEthernet 2/0/1 as the source interface for IPv6 NetStream traditional
data packets.
<Sysname> system-view
[Sysname] ipv6 netstream export source interface gigabitethernet 2/0/1
# In AS aggregation mode view, specify GigabitEthernet 2/0/2 as the source interface for IPv6
NetStream aggregation data packets.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns6-aggregation-as] ipv6 netstream export source interface gigabitethernet 2/0/2
402