Mitsubishi Electric R16MTCPU Programming Manual page 62

■Description, range, setting side, data type
Setting data Description
(n1) (First I/O No. of the target CPU)/16
Value to specify actually is the following.
CPU No.2: 3E1H, CPU No.3: 3E2H, CPU No.4: 3E3H
(S1) Axis No. ("Jn")
R64MTCPU: J1 to J64
R32MTCPU: J1 to J32
R16MTCPU: J1 to J16
(n2) Speed to change
*1
(D1) Complete devices
• (D1+0): Device which make turn on for one scan at accept completion of instruction.
• (D1+1): Device which make turn on for one scan at accept abnormal completion of
instruction. ("D1+0" also turns on at the abnormal completion.)
*1
(D2) Complete status storage device
*1 Omission possible with both of (D1) and (D2) omission.
*2 Motion CPU cannot be set as CPU No.1 in the Multiple CPU configuration.
*3 "n" shows the numerical value correspond to axis No. (n=1 to 64)
*4 The setting range of each setting unit for (n2) is shown below.
Unit (n2) usable range
mm -600000000 to 600000000 (10
inch -600000000 to 600000000 (10
degree -2147483647 to 2147483647 (10
pulse -2147483647 to 2147483647[pulse/s]
*5 When the "speed control 10  multiplier setting for degree axis" is set to "valid", the setting range is -2147483647 to 2147483647 (10
2
[degree/min]).
Processing details
■Controls
• The speed of axis specified with (S1) is changed to the speed specified with (n2) during positioning or JOG operating.
• There is not an interlock signal on the buffer memory during speed change. When the multiple instructions are executed
toward the same axis of same Motion CPU, the speed is changed to specified value by last instruction.
• Acceleration/deceleration time at speed change can be changed by setting the acceleration/deceleration time change
parameter of the axis specified with (S1). Refer to the following for acceleration/deceleration time change parameter and
acceleration/deceleration time change function.
MELSEC iQ-R Motion controller Programming Manual (Positioning Control)
2 MOTION DEDICATED PLC INSTRUCTION
60
2.2 Motion Dedicated PLC Instruction
*2
*3
to execute the speed change.
-2
[mm/min])
-3
[inch/min])
-3 *5
[degree/min])
Setting range Set by Data type
3E1H to 3E3H User 16-bit binary
1 to 64 User Character
string
*4
User 32-bit binary

System Bit

System Word
-