Clearing Interface Counters - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Clearing Interface Counters

The counters in the show interfaces command are reset by the clear counters command. This

command does not clear the counters any SNMP program captures.

To clear the counters, use the following the command.

Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical

interfaces or selected ones. Without an interface specified, the command clears all interface counters.

EXEC Privilege mode

clear counters [interface] [vrrp [vrid] | learning-limit]

(OPTIONAL) Enter the following interface keywords and slot/port or number information:

For a loopback interface, enter the keyword loopback then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-channel then a number.

For the management interface, enter the keyword ManagementEthernet 0/0. The slot number is

0; the port number is 0.

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-

unit / port-id

where pe-id is a port-extender ID number from 0 to 255; unit-number is a PE stack-unit number

from 0 to 7; port-id is a port number from 1 to 48.

For a VLAN, enter the keyword vlan then a number.

(OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a

number from 1 to 255 as the vrid.

(OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC

learning limit on the interface, enter the keywords learning-limit.

Example of the clear counters Command

When you enter this command, confirm that you want to clear the interface counters for the specified

Dell#clear counters te 0/0

Clear counters on TengigabitEthernet 0/0 [confirm]