Dell C9000 Series Networking Configuration Manual page 754

• Disable OSPF.
CONFIGURATION mode
no router ospf process-id
• Reset the OSPFv2 process.
EXEC Privilege mode
clear ip ospf process-id
• View the current OSPFv2 status.
EXEC mode
show ip ospf process-id
Example of Viewing the Current OSPFv2 Status
Dell#show ip ospf 55555
Routing Process ospf 55555 with ID 10.10.10.10
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Number of area in this router is 0, normal 0 stub 0 nssa 0
Dell#
Enabling Multi-Process OSPF (OSPFv2, IPv4 Only)
Multi-process OSPF allows multiple OSPFv2 processes on a single router.
For more information, refer to
When configuring a single OSPF process, follow the same steps previously described. Repeat them as often as
necessary for the desired number of processes. After the process is created, all other configurations apply as
usual.
1 Assign an IP address to an interface.
CONFIG-INTERFACE mode
ip address ip-address mask
Format: A.B.C.D/M.
If you are using a Loopback interface, refer to
2 Enable the interface.
CONFIG-INTERFACE mode
no shutdown
3 Return to CONFIGURATION mode to enable the OSPFv2 process globally.
CONFIGURATION mode
router ospf process-id [vrf]
The range is from 0 to 65535.
After the OSPF process and the VRF are tied together, the OSPF process ID cannot be used again in the
system.
Multi-Process OSPF (OSPFv2, IPv4 Only)
Loopback Interfaces.
Open Shortest Path First (OSPFv2 and OSPFv3) 754