Dell C9000 Series Networking Configuration Manual page 322

Examples of the show Commands
The following example shows the show dot1p-queue mapping command.
Dell(conf)# show dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 0 0 0 1 2 3 3 3
The following example shows the show dcb command.
Dell#show dcb linecard 2 port-set 0
DCB Status: Enabled, PFC Queue Count: 2
linecard Total Buffer PFC Total Buffer PFC Shared Buffer PFC Available Buffer
PP (KB)
-----------------------------------------------------------------------------
2 0 11210
The following example shows the output of the show qos dcb-map test command.
Dell#show qos dcb-map test
-----------------------
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:50
Priorities:3 4
The following example shows the show interfaces pfc summary command.
Dell# show interfaces tengigabitethernet 1/4 pfc summary
Interface TenGigabitEthernet 1/4
Admin mode is on
Admin is enabled
Remote is enabled, Priority list is 4
Remote Willing Status is enabled
Local is enabled
Oper status is Recommended
PFC DCBx Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 45556 pause quantams
Application Priority TLV Parameters :
--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
Dell# show interfaces tengigabitethernet 1/4 pfc detail
Interface TenGigabitEthernet 1/4
Admin mode is on
Admin is enabled
Remote is enabled
Remote Willing Status is enabled
Local is enabled
(KB)
7488
PFC:OFF
PFC:ON
(KB) (KB)
2496 4992
Data Center Bridging (DCB) 322