Dell C9000 Series Networking Configuration Manual page 870

Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

3
source {interface | range }
direction {rx | tx | both}
5
erpm source-ip-address dest-ip-
address
6
flow-based enable
7
no disable
The following example shows a sample ERPM configuration.
Dell(conf)#monitor session 0 type erpm
Dell(conf-mon-sess-0)#source tengigabitethernet 0/9 direction rx
Dell(conf-mon-sess-0)#source port-channel 1 direction tx
Dell(conf-mon-sess-0)#erpm source-ip 1.1.1.1 dest-ip 7.1.1.2
Dell(conf-mon-sess-0)#no disable
Dell(conf)#monitor session 1 type erpm
Dell(conf-mon-sess-1)#source vlan 11 direction rx
Dell(conf-mon-sess-1)#erpm source-ip 5.1.1.1 dest-ip 3.1.1.2
Dell(conf-mon-sess-1)#flow-based enable
Dell(conf-mon-sess-1)#no disable
Dell# show monitor session
SessID Source
Destination Dir Mode Source IP Dest IP
------ ------
----------- --- ---- --------- --------
0
Te 0/9
remote-ip
0
Po 1
remote-ip
1
Vl 11
remote-ip
The next example shows the configuration of an ERPM session in which VLAN 11 is monitored as the source
interface and a MAC ACL filters the monitored ingress traffic.
Dell(conf)#mac access-list standard flow
Dell(config-std-macl)#seq 5 permit 00:00:0a:00:00:0b count monitor
Dell#show running-config interface vlan 11
!
interface Vlan 11
no ip address
tagged TenGigabitEthernet 0/1-3
mac access-group flow in
shutdown
Dell#
rx
Port
1.1.1.1 7.1.1.2
tx
Port
1.1.1.1 7.1.1.2
rx
Flow
5.1.1.1 3.1.1.2
Monitoring-Session configuration mode.
The session number needs to be unique
and not already defined.
Specify the source port or range of ports.
Specify the ingress (rx), egress (tx), or both
ingress and egress traffic to be monitored.
You can enter mulitple source statements
in an ERPM monitoring session.
Specify the source IP address and the
destination IP address to which
encapsulated mirrored traffic is sent.
Specify ERPM to be performed on a flow-
by-flow basis or if you configure a VLAN
source interface. Enter no flow-based
disable to disable flow-based ERPM.
Enter the no disable command to
activate the ERPM session.
Port Monitoring
870

Advertisement

Table of Contents
loading

Table of Contents