Dell C9000 Series Networking Configuration Manual page 104

INTERFACE mode
dot1x authentication
NOTE: You must enabled dot1x authentication globaly as well as in interface mode on which
supplicant is connected.
Examples of Verifying that 802.1X is Enabled Globally or on an Interface
Verify that 802.1X is enabled globally and at the interface level using the show running-config | find
dot1x command from EXEC Privilege mode.
The bold text show that 802.1x has been enabled. By default, ports are not authorized.
Dell#show running-config | find dot1x
dot1x authentication
!
[output omitted]
!
interface TenGigabitEthernet 2/1
no ip address
dot1x authentication
no shutdown
!
Dell#
View 802.1X configuration information for an interface using the show dot1x interface command.
The bold lines show that 802.1X is enabled on all ports unauthorized by default.
Dell#show dot1x interface TenGigabitEthernet 2/1
802.1x information on Te 2/1:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts: NONE
Critical VLAN:
Critical VLAN id:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Static-MAB:
Static-MAB Profile:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Enable
AUTO
UNAUTHORIZED
Disable
None
Disable
NONE
Disable
NONE
Disable
NONE
Enable
Enable
Disable
NONE
30 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Initialize
Initialize
Disable
Disable
30 seconds
802.1X 104