Table of Contents
Advertisement
Systems with Port Extender
The following diagram illustrates PE 1 connected to System A and PE 2 connected to System B.
Figure 106. Systems with Port Extender — Before setting up Dual Homing
You can connect System A and System B and configure them as VLT peers as follows:
1
Ensure that System A and System B are upgraded to OS 9.10(0.). Ensure that PE IDs of PE 1 and PE 2 are
different. The IDs should be unique and cannot overlap during the configuration.
2
Enter VLT-domain configuration mode for a specified VLT domain. Ensure that both the systems are
configured with the same VLT domain ID.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
3
Configure the default MAC address for the domain by entering a new MAC address.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
The mac-address format is nn:nn:nn:nn:nn:nn.
4
Configure the unique unit ID (0 or 1) to each peer switch.
VLT DOMAIN CONFIGURATION mode
unit-id {0 | 1}
Configure a different unit ID (0 or 1) on each peer switch.
Port Extenders (PEs)
834
Advertisement
Table of Contents
Troubleshooting
