Resetting an Interface to its Factory
Default State
You can reset any configurations applied on an interface to its factory default state. To reset the
configuration, perform the following steps:
1
View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 893
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
2
Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3
Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Interfaces
502