Table of Contents
Advertisement
INTERFACE mode
[no] port-channel-protocol lacp
The default is LACP disabled.
This command creates context.
•
Configure LACP mode.
LACP mode
[no] port-channel number mode [active | passive | off]
•
number: cannot statically contain any links.
The default is LACP active.
•
Configure port priority.
LACP mode
[no] lacp port-priority priority-value
The range is from 1 to 65535 (the higher the number, the lower the priority).
The default is 32768.
LACP Configuration Tasks
The following configuration tasks apply to LACP.
•
Creating a LAG
•
Configuring the LAG Interfaces as Dynamic
•
Setting the LACP Long Timeout
•
Monitoring and Debugging LACP
•
Configuring Shared LAG State Tracking
Creating a LAG
To create a dynamic port channel (LAG), use the following command. First you define the LAG and then the
LAG interfaces.
•
Create a dynamic port channel (LAG).
CONFIGURATION mode
interface port-channel
•
Create a dynamic port channel (LAG).
CONFIGURATION mode
switchport
Link Aggregation Control Protocol (LACP)
624
Advertisement
Table of Contents
Troubleshooting
