Enabling Fefd On An Interface - Dell C9000 Series Networking Configuration Manual

Te 1/0 Normal 3
Te 1/1 Normal 3
Te 1/2 Normal 3
Te 1/3 Normal 3
Dell#show run fefd
!
fefd-global mode normal
fefd-global interval 3

Enabling FEFD on an Interface

To enable, change, or disable FEFD on an interface, use the following commands.
• Enable FEFD on a per interface basis.
INTERFACE mode
fefd
• Change the FEFD mode.
INTERFACE mode
fefd [mode {aggressive | normal}]
• Disable FEFD protocol on one interface.
INTERFACE mode
fefd disable
Disabling an interface shuts down all protocols working on that interface's connected line. It does not
delete your previous FEFD configuration which you can enable again at any time.
To set up and activate two or more connected interfaces, use the following commands.
1 Setup two or more connected interfaces for Layer 2 or Layer 3.
INTERFACE mode
ip address ip address, switchport
2 Activate the necessary ports administratively.
INTERFACE mode
no shutdown
3
INTERFACE mode
fefd {disable | interval | mode}
Example of Viewing FEFD Configuration
Dell(conf-if-te-1/0)#show config
!
interface TengigabitEthernet 1/0
no ip address
switchport
fefd mode normal
(second)
Bi-directional
Admin Shutdown
Admin Shutdown
Admin Shutdown
Layer 2 652