Dell C9000 Series Networking Configuration Manual page 809

The below step shows a step-by-step example of how to create a rule for a redirect list by configuring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information
Creating a Rule Example:
Dell(conf-redirect-list)#redirect ?
A.B.C.D
Dell(conf-redirect-list)#redirect 3.3.3.3 ?
<0-255>
icmp
ip
tcp
udp
Dell(conf-redirect-list)#redirect 3.3.3.3 ip ?
A.B.C.D
any
host
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 ?
Mask
format
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 ?
A.B.C.D
port number
fin
gt
greater port number
lt
lower port number
neq
given port number
psh
range
range of port numbers
rst
syn
urg
cr
Dell(conf-redirect-list)#redirect 1.1.1.1 udp any
any ?
eq
port number
gt
greater port number
lt
lower port number
neq
given port number
range
range of port numbers
Delete a rule with the no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination
router IP address
Forwarding router's address
An IP protocol number
Internet Control Message Protocol
Any Internet Protocol
Transmission Control Protocol
User Datagram Protocol
Source address
Any source host
A single source host
A.B.C.D or /nn Mask in dotted decimal or in slash
Destination address
Match on the fin bit
Match only packets with a
Match only packets with a
Match only packets not on a
Match on the psh bit
Match only packets in the
Match on the rst bit
Match on the syn bit
Match on the urg bit
Match only packets on a given
Match only packets with a
Match only packets with a
Match only packets not on a
Match only packets in the
Policy-based Routing (PBR) 809