Table of Contents
Advertisement
Configuring FIP Snooping
You can enable FIP snooping globally on all FCoE VLANs on a switch or on an individual FCoE VLAN.
By default, FIP snooping is disabled.
To enable FCoE transit on the switch and configure the FCoE transit parameters on ports, follow these steps.
1
Configure FCoE.
To configure FCoE transit, refer to the
NOTE:
DCB/DCBx is enabled when either of these configurations is applied.
2
Save the configuration on the switch.
EXEC Privilege mode.
write memory
3
Reload the switch to enable the configuration.
EXEC Privilege mode.
reload
After the switch is reloaded, DCB/DCBx is enabled.
4
Enable the FCoE transit feature on a switch.
CONFIGURATION mode.
feature fip-snooping
5
Enable FIP snooping on all VLANs or on a specified VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
6
Configure the port for bridge-to-FCF links.
INTERFACE mode or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE:
To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a command;
for example, no feature fip-snooping or no fip-snooping enable.
FCoE Transit Configuration Example
FCoE Transit
430
Advertisement
Table of Contents
Troubleshooting
