Configuring The Distance Of A Route; Changing The Is-Type - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Metric Sytle

Correct Value Range

wide transition

0 to 16777215

narrow transition

To view the interface's current metric, use the show config command in INTERFACE mode or the show

isis interface command in EXEC Privilege mode.

Configuring the Distance of a Route

To configure the distance for a route, use the following command.

Configure the distance for a route.

ROUTER ISIS mode

To change the IS-type, use the following commands.

You can configure the system to act as a Level 1 router, a Level 1-2 router, or a Level 2 router.

To change the IS-type for the router, use the following commands.

Configure IS-IS operating level for a router.

ROUTER ISIS mode

is-type {level-1 | level-1-2 | level-2-only}

Default is level-1-2.

Change the IS-type for the IS-IS process.

ROUTER ISIS mode

is-type {level-1 | level-1-2 | level-2}

Example of the show isis database Command to View Level 1-2 Link State Databases

To view which IS-type is configured, use the show isis protocol command in EXEC Privilege mode. The

show config command in ROUTER ISIS mode displays only non-default information, so if you do not

change the IS-type, the default value (level-1-2) is not displayed.

The default is Level 1-2 router. When the IS-type is Level 1-2, the software maintains two Link State databases,

one for each level. To view the Link State databases, use the show isis database command.

Dell#show isis database

IS-IS Level-1 Link State Database

eljefe.00-00 * 0x00000009

eljefe.01-00 * 0x00000001

LSP Checksum LSP Holdtime ATT/P/OL

Intermediate System to Intermediate System