Chapter 3: Installation
10 (24 V gnd)
9 (+24 V)
8 (-)
7 (+)
Internal to Analyzer
K1 = Custom Computer Terminal
Step 5: Installing the Printer, USB, and Serial Connections
If you have not already done so, replace the electrical enclosure cover by securing the two set screws with a
Phillips screwdriver. Then, close and latch the Analyzer front panel.
Before installing the printer cable, USB flash drive, or serial cable, you must first remove the cover plate from the
Analyzer. Loosen the two thumb screws on the cover plate and remove the plate.
GE Analytical Instruments ©2010
Method 2 - Using Customer's External Power Supply
TB2
Local Control
Figure 5: Wiring Option for Binary Input Using External Supply
Figure 6: Input and Output Connectors
K1
Conduit
External to Analyzer
53 of 226
12V - 28V
-
+
DC
DLM 74001-04 Rev. A