Table of Contents
Advertisement
5.
Inspect new filter for shipping damage. Check
sealing end of filter. Do not install a damaged
filter.
6.
Insert new filter properly into air cleaner body.
Make sure filter is sealed properly by applying
pressure to outer rim of filter when installing. Do
not press on flexible center of filter.
7.
Reinstall cover and secure latches.
Changing Engine Oil and Filter
(Fig. 40 & 41)
Change oil and filter initially after the first 50 hours of
operation, thereafter, change oil and filter every 100
hours.
1.
Raise bed (if so equipped) and place safety
support on extended lift cylinder to hold up bed.
2.
Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
1. Engine Oil Drain Plug
1. Engine Oil Filter
3.
Remove oil filter. Apply a light coat of clean oil
to the new filter seal before screwing it on. Screw
filter on until gasket contacts mounting plate, then
tighten
1
⁄
to
2
⁄
of a turn. DO NOT OVER-
2
3
TIGHTEN.
1
Figure 40
1
Figure 41
4.
Add oil to crankcase, refer to Check Engine Oil,
p. 18.
Fuel System (Fig. 42)
Fuel Lines and Connections
Check lines and connections every 600 hours or
yearly, whichever comes first. Inspect for
deterioration, damage, or loose connections.
Fuel Filters
Replace filter canister after every 600 hours of
operation.
1.
Raise bed (if so equipped) and place safety
support on extended lift cylinder to hold up bed.
2.
Place a clean container under the fuel filtesr.
1. Fuel filter
3.
Loosen R-clamps securing filters to frame..
4.
Remove clampssecuring fuel filters to fuel lines.
5.
Install new fuel filters to fuel lines with clampls
previously removed. Filters must be mounted so
arrow points toward carburetor.
Removing Debris from Engine
Cooling System (Fig. 43)
Remove debris from engine area and radiator daily,
clean more frequently in dirty conditions.
1.
Turn engine off. Clean engine area thoroughly of
all debris.
42
1
Figure 42
Advertisement
Table of Contents
