Table of Contents
Advertisement
vehicle and your head.
M. If ever unsure about safe operation, STOP
WORK and ask your supervisor.
19. Do not touch engine, transaxle, radiator, muffler
or muffler shield while engine is running or soon
after it has stopped because these areas may be
hot enough to cause burns.
20. If the machine ever vibrates abnormally, stop
immediately, turn engine off, wait for all motion
to stop and inspect for damage. Repair all damage
before commencing operation.
21. Before getting off the seat:
A. Stop movement of the machine.
B. Lower the bed.
C. Shut engine off and wait for all movement to
stop.
D. Set parking brake.
E. Remove key from ignition.
F.
Block wheels if machine is on an incline.
Maintenance
22. Before servicing or making adjustments to the
machine, stop engine, set parking brake and
remove key from ignition to prevent accidental
starting of the engine.
23. Never work under a raised bed without placing
bed safety support on fully extended cylinder rod.
24. Make sure all hydraulic line connectors are tight,
and all hydraulic hoses and lines are in good
condition before applying pressure to the system.
25. Keep body and hands away from pin hole leaks or
nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, not hands, to
search for leaks. Hydraulic fluid escaping under
pressure can have sufficient force to penetrate
skin and do serious damage. If fluid is injected
into the skin it must be surgically removed within
a few hours by a doctor familiar with this form of
injury or gangrene may result.
26. Before disconnecting or performing any work on
the hydraulic system, all pressure in system must
be relieved by stopping engine, cycling dump
valve from raise to lower and/or lowering box and
attachments. Place the remote hydraulics lever in
the float position. If box must be in raised
position, secure with safety support.
27. To make sure entire machine is in good condition,
keep all nuts, bolts and screws properly tightened.
28. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves and
accumulation of dirt.
29. If the engine must be running to perform a
maintenance adjustment, keep hands, feet,
clothing, and any parts of the body away from the
engine and any moving parts. Keep everyone
away.
30. Do not overspeed engine by changing governor
settings. Maximum engine speed is 3650 rpm. To
assure safety and accuracy, have an Authorized
TORO Distributor check maximum engine speed
with a tachometer.
31. If major repairs are ever needed or assistance is
required, contact an Authorized TORO
Distributor.
32. To be sure of optimum performance and safety,
always purchase genuine TORO replacement
parts and accessories. Replacement parts and
accessories made by other manufacturers could be
dangerous. Altering this vehicle in any manner
may affect the vehicle's operation, performance,
durability or its use may result in injury or death.
Such use could void the product warranty of The
TORO Company.
33. This vehicle should not be modified without the
TORO Company's authorization. Direct any
inquiries to:
The TORO Company Commercial Division
Vehicle Engineering Dept., 300 West 82nd St.
Bloomington, Minnesota 55420-1196 USA
6
Advertisement
Table of Contents
