Table of Contents
Advertisement
Install Rear Fenders (Fig. 1–2)
1.
Loosen the locknuts and capscrews securing tail
light plates to right and left frame brackets.
2.
Pivot tail light plates rearward and tighten
capscrews and locknuts.
1. Tail light plate
2. Frame bracket
3. Tail light mounting bracket
3.
Secure rear of each tail light plate to rear of frame
brackets with a
5
⁄
1 6
D. flatwasher and nut, as shown in figure 1.
4.
On left side, remove (2) capscrews, washers and
nuts securing tail light mounting bracket to tail
light plate.
1. Fender
2. Fender mounting bracket
5.
Position a fender over each tail light plate,
aligning mounting holes.
6.
On left side, loosely secure tail light mounting
Figure 1
-18 x 1" lg. capscrew, .344" I.
Figure 2
bracket, rear of fender and tail light plate together
with (2) capscrews, washers and nuts, previously
removed.
7.
On right side, secure rear of fender to tail light
plate with (2)
flatwashers and nuts
8.
Loosely secure front of each fender mounting
bracket to frame with a
and locknut.
9.
Loosely secure side of each fender to frame (3)
3/8-16 x 1" lg. truss head screws and locknuts.
Note: Capscrews securing fronts of fenders to
mounting brackets may have to be loosened to
align all mounting holes.
10. Tighten all fasteners.
Install Wheels (Fig. 3)
1.
Remove and discard fasteners securing wheels.
2.
Mount wheels and torque nuts to 61–75 Nm
(45–55 ft lb.).
1. Wheel
2. Wheel Nut
Install Steering Wheel (Fig. 4)
1.
Remove jam nut from steering shaft. Slide foam
seal, steering wheel and washer onto steering
shaft.
13
1
⁄
-20 x 1" lg. capscrews, .281" I. D.
4
1
⁄
-20 x 1" lg. capscrew
4
Figure 3
Advertisement
Table of Contents
