Table of Contents
Advertisement
2
1. Accelerator cable
2. Ball joint
Changing Transaxle/Hydraulic
Fluid (Fig. 50)
Change Transaxle hydraulic fluid, filter and clean
strainer every 800 hours.
1.
Position the vehicle on a level surface, stop
engine, engage the parking brake and remove key
from ignition switch.
2.
Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
2
1. Hydraulic Reservoir
Drain plug
2.
3.
Fill reservoir with approximately 7.1 l (7.5 qt.) of
Dexron III ATF. Refer to Check Hydraulic Fluid,
p 20.
4.
Start engine and operate to fill hydraulic system.
Recheck oil level and replenish, if required.
Important
Use only hydraulic fluids specified.
Other fluids could cause system damage.
1
Figure 49
Figure 50
Replacing Hydraulic Filter
(Fig. 51)
Initially, replace the hydraulic filter after 10 operating
hours; thereafter, replace the filter every 800 hours.Use
the Toro replacement filter (Part No. 54-0110).
Important
warranty on some components.
1.
Position vehicle on a level surface, stop engine,
engage parking brake and remove key from
ignition switch.
2.
Clean area around filter mounting area. Place
drain pan under filter and remove filter.
1. Hydraulic Filter
2. Gasket
3.
Lubricate new filter gasket.
1
4.
Assure filter mounting area is clean. Screw filter
on until gasket contacts mounting plate. Then
tighten filter one-half turn.
5.
Start engine and let run for about two minutes to
purge air from the system. Stop the engine and
check the hydraulic oil level and for leaks.
Change Front Differential Oil
Front-Wheel Drive Models Only (Fig. 52)
Change front differential oil every 800 hours.
1.
Position vehicle on a level surface, stop engine,
engage parking brake and remove key from
ignition switch.
2.
Clean area around drain plug on side of
45
Use of any other filter may void the
2
1
Figure 51
Advertisement
Table of Contents
