Changing Engine Oil And Filter; Fuel System - Toro 07360 Operator's Manual

Î Î Î Î
1
Figure 43
1. Air cleaner cover
2. Before removing the filter, use low pressure air (40 psi,
clean and dry) to help remove large accumulations of
debris packed between the outside of the primary filter
and the canister.
Important Avoid using high pressure air which could
force dirt through the filter into the intake tract. This
cleaning process prevents debris from migrating into the
intake when the primary filter is removed.
3. Remove and replace the primary filter.
Note: Cleaning of the used element is not recommended
due to the possibility of damage to the filter media.
4. Inspect the new filter for shipping damage, checking the
sealing end of the filter and the body.
Important Do not use a damaged element.
5. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister.
Important
Do not apply pressure to the flexible center
of the filter.
6. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
7. Install the cover orienting the rubber outlet valve in a
downward position–between approximately 5:00 to
7:00 when viewed from the end.
8. Secure the cover latches. Reset the indicator if it is
showing red, if so equipped.

Changing Engine Oil And Filter

Change oil and filter initially after the first 50 hours of
operation, thereafter, change oil and filter every 200 hours.
1. Raise bed (if so equipped) and place safety support on
extended lift cylinder to hold up bed.
2
2. Filter
41
2. Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
1
Figure 44
1. Engine oil drain plug
3. Remove oil filter. Apply a light coat of clean oil to the
new filter seal before screwing it on. Screw filter on
until gasket contacts mounting plate, then tighten 1/2 to
2/3 of a turn. DO NOT OVER–TIGHTEN.
Figure 45
1. Engine oil filter
4. Add oil to crankcase, refer to Check Engine Oil.

Fuel System

Fuel Lines and Connections
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration, damage, or
loose connections.
Fuel Filters
Replace filter canisters after every 400 hours of operation.
1. Raise bed (if so equipped) and place safety support on
extended lift cylinder to hold up bed.
2. Place a clean container under fuel filters.
3. Loosen R–clamps securing filters to frame.
1