Toro 07211TC Operator's Manual page 17

for full bed installation and front slots are for
bed installation.
Note: The engine may need to be started to
extend or retract cylinders for alignment with
holes. Keep fingers out!
Note: The unused slot can be plugged with a
capscrew and nut to prevent assembly errors.
4. Start the engine and engage the hydraulic lift
lever to raise the bed. Release the lift lever and
turn off the engine. Secure the raised bed with a
hoist or block it to prevent it from accidentally
falling.
5. Install the lynch pins to the inside ends of the
clevis pins.
Note: If the automatic tail gate release has been
installed on bed, make sure the front dump link
rod has been placed on inside of left side clevis
pin before the lynch pin is installed.
6. Once cylinder installation has been completed,
the bed safety support can be used to prevent
accidental lowering of the bed. Refer to Using the
Bed Safety Support, page 39.
2 ⁄ -
3
17