Table of Contents
Advertisement
Adjusting the High-Low Cable
(Fig. 60)
Check adjustment every 200 hours.
1.
Remove clevis pin securing High-Low cable to
transaxle.
2.
Loosen clevis jam nut and adjust clevis so clevis
hole aligns with hole in transaxle bracket.
3.
Reinstall clevis pin and tighten jam nut after
adjustment has been attained.
2
1. Shift arm (1st—Rev.)
2. Shift arm (2nd—3rd)
3. Shift arm (High—low)
Adjusting Differential Lock Cable
(Fig. 61)
Check adjustment every 200 hours.
1.
Move differential lock lever to Off position.
2.
Loosen jam nuts securing differential lock cable
to bracket on transaxle.
3
Figure 60
1. Differential lock cable
2. Transaxle bracket
3. Spring
3.
While pulling back on spring, adjust jam nuts to
1
obtain 0.89mm ± 0.64mm ( 0.035" ± .025") gap
between spring hook and O. D. of hole in
transaxle lever.
4.
Tighten jam nuts after adjustment has been
attained and recheck.
Inspect Brakes
Visually inspect brakes for worn brake shoes after
every 600 hours of operation.
Inspect Tires
Check tire condition at least every 200 hours of
operation. Operating accidents, such as hitting curbs,
can damage a tire or rim and also disrupt wheel
alignment, so inspect tire condition after an accident.
Front Wheel Toe-In (Fig. 62–63)
After every 400 operating hours or annually, check
front wheel toe-in.
1.
Measure center-to-center distance (at axle height)
at front and rear of steering tires. Front
measurement must be equal to the rear
measurement 3mm (±
49
2
3
Figure 61
1
⁄
in.).
8
1
0.89mm ±0.64mm
Advertisement
Table of Contents
