Table of Contents
Advertisement
Important
: a cracked fouled, dirty or otherwise
malfunctioning spark plug must be replaced. Do not
sand blast, scrape, or clean electrodes by using a wire
bursh because grit may eventually release from the
plug and fall into the cylinder. The result is usually a
damaged engine.
4.
Set the air gap between the center and side of the
electrods at 0.81mm. Install a correctly gapped
spark plug and tighten the plug to 20–27 Nm (15-
20 ft. lb). If a torque wrench is not used, tight
firmly.
5.
Install the spark plug wires.
Adjusting the Brake Pedal
(Fig. 55–56)
Check adjustment every 200 hours.
1.
Loosen jam nut on link rod ball joint.
2.
Rotate rod until gap between brake pedal and up
stop is 0,5mm—2mm (0.020–0.080").
Figure 54
1
1. Link rod ball joint
3.
Tighten jam nut after adjustment has been
attained.
1. Brake pedal
2. Clutch pedal
3. Clutch pedal up stop
Adjusting the Clutch Pedal
(Fig. 57–58)
Check adjustment every 200 hours.
1.
Loosen jam nuts securing clutch cable to bracket
on bell housing.
47
Figure 55
3
2
Figure 56
1
Advertisement
Table of Contents
