Table of Contents
Advertisement
1. Center-to-center distance
2.
To adjust, loosen jam nuts at both ends of tie rod.
1. Tie rod
3.
Rotate tie rod to move front of tire inward or
outward.
4.
Tighten tie rod jam nuts when adjustment is
correct.
Inspect Constant Velocity Boot
Four-Wheel Drive Models Only
After every 200 operating hours, inspect constant
velocity boot for cracks, holes or a loose clamp.
Emergency Box Raising (without
starting the engine)
The box can be raised in an emergency by cranking
the starter and holding the lift lever. Run starter for 15
seconds then wait 60 seconds before engaging starter
again.
If engine will not crank, the load and box (attachment)
must be removed to service engine or transaxle.
Figure 62
1
Figure 63
Fuses (Fig. 64)
There are 3 fuses in the machine's electrical system.
They are located under right side of dash panel.
FUSES
OPEN
LIGHTS & HORN
DASH
IGNITION
1. Fuse block
Jump Starting Procedure
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in vehicle,
observe the following warnings:
•
Never jump start with a voltage sources greater
than 15 volts D. C. This will dam age the
electrical system.
•
Never attempt to jump start a discharged battery
that is frozen. It could rupture or explode during
jump starting.
•
Observe all battery warnings while jump
starting your vehicle.
•
Be sure your vehicle is not touching the jump
start vehicle.
•
Connecting cables to the wrong post could
result in personal injury and/or damage to the
electrical system.
1.
Loosen knobs securing battery cover to battery
base and slide cover off.
50
Figure 64
WARNING
—
10A
7.5A
7.5A
1
Advertisement
Table of Contents
