Using The Rear Cargo Bed Accessory Mount; Stopping The Machine; Loading The Cargo Bed - Toro Workman GTX Operator's Manual

Using the Rear Cargo Bed
Accessory Mount
Use the rear cargo bed accessory mount to attach
accessories to the rear of the machine.
Capacity: 45 kg (100 lb)
1. Loosen the "T" handle by rotating it clockwise
(Figure 19).
Figure 19
1. Receiver
2. Insert your accessory into the receiver until the
holes align (Figure
3. Secure the assembled accessory to the receiver
tube using the clevis pin and hairpin cotter
supplied with the accessory.
4. Tighten the "T" handle by rotating it
counterclockwise
Figure 20
1. "T" handle
2. "T" handle
19).
(Figure 20).

Stopping the Machine

Important:
When stopping the machine on
an incline, use the service brakes to stop the
machine and engage the parking brake to hold the
machine in place. Using the accelerator to stall
the machine on the hill can overheat the motor or
drain the batteries.
1. Remove your foot from the accelerator pedal.
2. Slowly press the brake pedal to apply the service
brakes until the machine comes to a complete
stop.
Note:
The stopping distance may vary
depending on the machine load and speed.

Loading the Cargo Bed

Use the following guidelines when loading the cargo
bed and operating the machine:
•
Observe the weight capacity of the machine and
g034545
limit the weight of the load that you carry in the
cargo bed as described in
14) and on the gross vehicle weight tag of the
machine.
Note:
The load rating is specified for machine
operation on a level surface only.
•
Reduce the weight of the load that you carry in the
cargo bed when operating the machine on hills
and rough terrain.
•
Reduce the weight of the load that you carry when
the materials are tall (and have a high center of
gravity), such as a stack of bricks, landscaping
timbers, or fertilizer bags. Distribute the load as
low as possible to ensure that the load does not
reduce your ability to see behind the machine
when operating it.
•
Keep loads centered by loading the cargo bed as
follows:
– Evenly position the weight in the cargo bed
from side to side.
Important:
g034546
occur if the cargo bed is loaded to 1 side.
– Evenly position the weight in the cargo bed
from front to back.
Important:
machine may tip over if you position the
load behind the rear axle and the traction
on the front tires is reduced.
•
Use extra caution when transporting oversized
loads in the cargo bed, particularly when you
cannot center the weight of the oversize load to
the cargo bed.
22
Specifications (page
Tipping over is more likely to
Loss of steering control or the