Codabar Message Length - Honeywell Voyager 1202G-BF User Manual

Concatenation Timeout
When searching for bar codes during concatenation, you may wish to set a delay used to find the next bar code. Set
the length (in milliseconds) for this delay by scanning the following bar code, then setting the timeout (from 1-65535
milliseconds) by scanning digits from the
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan
the following Codabar Redundancy bar code, then scan a redundancy count between 0 and 10 on the
inside the back cover of this manual. Then scan the

Codabar Message Length

Scan the following bar codes to change the message length. Refer to
tional information. Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maximum Default = 80.
Minimum Message Length
8 - 4
Programming Chart, then scanning Save. Default = 750.
Concatenation Timeout
Save bar code. Default = 0.
Codabar Redundancy
Message Length Description
Programming Chart
(page 8-1) for addi-
Maximum Message Length