Block Check Character; Ncr Prefix; Ncr Suffix; Ncr Prefix/Suffix - Honeywell Voyager 1202G-BF User Manual

Block Check Character

When this selection is set to Transmit, the NCR Block Check Character (BCC) is expected with incoming messages and
transmitted with outgoing messages. Default = Transmit.
* Transmit

NCR Prefix

This selection allows you to program an NCR-specific prefix. Refer to the
1252), page A-2 to find the hex equivalent for the characters you want for the NCR prefix (typically, 02 for STX). Scan the
bar code below, then set the hex number (from 0-FF) by scanning digits from the
Default = 0.

NCR Suffix

This selection allows you to program an NCR-specific suffix. Refer to the
A-2 to find the hex equivalent for the characters you want for the NCR suffix (typically, 03 for ETX). Scan the bar code
below, then set the hex number (from 0-FF) by scanning digits from the
= 0D.

NCR Prefix/Suffix

When set to Transmit, both the NCR prefix and suffix are transmitted with bar codes. Usually, prefixes and suffixes are
programmed using the Data Editing selections (see
override any other prefix/suffix settings. Default = Don't Transmit.
Transmit
ASCII Conversion Chart (Code Page
NCR Prefix
ASCII Conversion Chart (Code Page
Programming
NCR Suffix
Data Editing beginning on page 6-1), however, the following commands
Don't Transmit
Programming Chart, then scanning Save.
Chart, then scanning Save. Default
* Don't Transmit
1252), page
2 - 29