Clear All Codes; Transmit Records Automatically; Transmit Records To Host; Batch Mode Transmit Delay - Honeywell Voyager 1202G-BF User Manual

Clear All Codes

If you want to clear the scanner's buffer of all data accumulated in Batch Mode, scan Clear All Codes.
Clear All Codes

Transmit Records Automatically

If you are operating in Inventory Batch Mode (see Inventory Batch Mode on page 3-11), you can transmit all stored data to
the host system when the scanner is placed in the base. If you don't want the records transmitted when the scanner is
placed in the base, scan the Don't Transmit Records Automatically bar code. Default = Don't Transmit Records Auto-
matically.
* Don't Transmit Records
Automatically
Transmit Records Automatically

Transmit Records to Host

If you are operating in Inventory Batch Mode (see Inventory Batch Mode on page 3-11), and your scanner is set to Don't
Transmit Records Automatically, you must scan the following bar code to transmit all stored records to the host system.
Transmit Inventory Records

Batch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the transmission of those scans is too fast for the appli-
cation to process. To program a transmit delay between accumulated scans, scan one of the following delays. Default =
Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays may be programmed. Contact
Technical Support (page 14-1) for additional information.
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Short
(250 ms)
3 - 15