Scanning While In Base Cradle; Paging; Paging Mode; Paging Pitch - Honeywell Voyager 1202G-BF User Manual

Scanning While in Base Cradle

If you want to be able to scan bar codes while the scanner is in the base, scan the following Scanning in Cradle On bar code.
If you want to only allow scanning when the scanner is out of the base, scan Scanning in Cradle Off. Default = Scanning in
Cradle On.
Scanning in Cradle Off
Note: When Scanning in Cradle Off is selected, the scanner will not scan any bar codes while it is in the base. It will only scan
when removed from the base.

Paging

Paging Mode

By default, the paging button on the base pages the scanner associated with that base. If you want the paging button on
your base to be disabled, scan the following Paging Mode Off bar code. When Paging Mode is off, the base will no longer
page the scanner when the button is pressed. The red LED on the base will remain lit to indicate that Paging Mode is off.
(This light will go out when the button is pressed, then back on when it's released.) Default = Paging Mode On.
* Paging Mode On
Pitch
Paging
When you press the Page button on the base, the scanner associated with that base will begin beeping (see
on page 4-3). You can set the pitch of the paging beep for the scanner by scanning one of the following bar codes. Default
= Low.
* Low (1000 Hz)
* Scanning in Cradle On
Paging Mode Off
Page Button
Medium (3250 Hz)
4 - 5