Resetting The Factory Defaults - Honeywell Voyager 1202G-BF User Manual

Resetting the Factory Defaults

This selection erases all your settings and resets the scanner to the original factory defaults.
If you aren't sure what programming options are in your scanner, or you've changed some options and want to restore the scan-
ner to factory default settings, first scan the Remove Custom Defaults bar code, then scan Activate Defaults. Power cycle
the scanner to reset it to the factory default settings.
Remove Custom Defaults
Note: If using a cordless system, scanning the Activate Defaults bar code also causes both the scanner and the base or Access
Point to perform a reset and become unlinked. The scanner must be placed in its base to re-establish the link before any
setup codes are entered. If using an Access Point, the linking bar code must be scanned. See
Operation (Voyager 1202g)
4-1 for additional information.
The Serial Programming Commands,
cated by an asterisk (*) on the programming pages).
beginning on page 3-1 or Cordless System Operation (Voyager 1202g-BF)
beginning on page 11-1 list the factory default settings for each of the commands (indi-
Activate Defaults
Cordless System
beginning on page
10 - 3