Table 5-13 Profiler Starting Procedure - Honeywell VRX180 User Manual

Setpoint Profiler
How to start a profiler
A profiler can be started from the Ready, Hold or End state.
Step
1 Press Display button until the Setpoint Trend
is displayed.
2 Press Tab button to display the profile menu.
3 Cursor is on Start. Press Enter.
ATTENTION
A profile can also be started by pressing the F1 button, but only if that profile's START parameter was
configured as SY1 F1. See Section 5.4.
202

Table 5-13 Profiler Starting Procedure

Action
Video Recorder – User Manual
Result/Notes
SP1 PROFIL01
PV 0.00
SP 0.00
SP1
PROFIL01
START
HOLD
RESET
ADVANCE
SHUTDOWN
EVENTS
DETAIL
SUMMARY
EDIT
LOAD
PV 0.00
SP 0.00
Profiler starts running at segment #1 if in Ready
or End or resumes running from its Hold state. If
in Ready state and Hot Start has been activated,
profiler will start at the first point in the profile
where the present value of PV #1 occurs. Event
outputs assume their states as of the beginning of
the running segment. Profiler status on lower
right of display indicates RUN after you start the
profiler.
500.00
0.00
0:00:00
SEG1/9
READY
500.00
0.00
0:00:00
SEG1/9
READY