Table of Contents
Advertisement
Installation
Overview of the Installation Procedure
24
Unpack the DVR
1.
Open the box and remove the Multi-Media LT DVR, the power cord, and the other
contents of the box (see
2.
Remove the plastic bag that surrounds the DVR.
3.
Store the box and packaging materials.
Caution
Do not remove factory seals on a Rapid Eye Multi-Media LT DVR. Doing so will
void your warranty.
There are no user-serviceable parts inside.
Damaged Unit or Missing Goods
In the unlikely event that the DVR is damaged, or parts are missing:
1.
Make a note of the DVR serial number, located on a sticker on the bottom of the DVR.
2.
Call your Rapid Eye supplier to describe the problem. The supplier will ask for the
DVR serial number and will assign a Return Merchandise Authorization (RMA)
number.
3.
Make a note of the RMA.
4.
Repack the DVR in its box, along with the other contents.
5.
Prominently display the RMA on the shipping carton.
6.
Return the packaged DVR to the location specified by your supplier.
After unpacking the DVR:
1.
Determine the best place to install and the ideal orientation of the Multi-Media LT unit
(horizontal or vertical). The unit is shipped ready to install in a horizontal position. See
Appendix C, Horizontal and Vertical Unit
on vertical installations.
2.
Connect one or more cameras to the DVR.
3.
According to the communications that you plan to use, connect the DVR either to a
telephone line, your local area network (LAN), or both.
4.
Power up the camera(s) and the DVR.
5.
For network connections, assign a TCP/IP Address to the DVR using:
•
The LocalView interface
•
A Mouse (included)
•
A Monitor (not included)
6.
Field-test the connection to the DVR.
Field technicians tasked with the initial steps of an installation will find these steps
expanded and explained in more detail in
Communications, page 20.
Table
2-1).
Installations, on
Cameras, page 20, and
Connecting
65, for more information
page
Advertisement
Table of Contents
