Load/Store Configuration; Table 4-69 Load/Store Config Files Prompts - Honeywell VRX180 User Manual

4.23 Load/Store Configuration

Instrument configurations can be stored to and loaded from floppy disk. The front door must be closed.
Configurations have filename extension .LNC.
Table 4-69 describes the Load/Store Config prompts.

Table 4-69 Load/Store Config Files Prompts

Prompt
FILE01
STORE CONFIG TO
DISK
DRYER01
RECORD01
UNIT01
REACTR01
KILN01
CALIB01
PRESS01
DEMIN01
BATCH01
LEHR01
STRLZR01
ZONE01
LOAD CONFIG Select a configuration
FROM DISK filename.
ATTENTION
Only function blocks that have been programmed are loaded to the instrument. Function blocks in the receiving
instrument are not replaced unless the incoming function blocks are programmed differently. For example, if the
instrument has AI1 and AI2 programmed, and the configuration being loaded from the floppy contains AI3 only,
then AI1 and AI2 are undisturbed on the instrument and AI3 is added. If the configuration being loaded contains a
different AI2 and a new AI3, then AI1 is undisturbed, AI2 is replaced by the different AI2, and AI3 is added.
Range/Selections
CYCLE01
PROD01
TANK01
LOOP01
CONFIG01
VESSEL01
WCHEM01
FURNCE01
CONTRL01
FERMTR01
LINE01
OVEN01
Video Recorder – User Manual
Programming Function Blocks and Features
Definition
Specify a filename and number (01-99) for the
configuration. Press Enter to store the configuration.
First you must clear the instrument's configuration memory.
Press Enter to clear, or Menu to abort and exit the menu.
Once the memory is clear, select a filename from the floppy
disk. Press Enter to load the configuration into the
instrument.
163