Cisco TelePresence System Codec C20 Reference Manual page 59

Cisco TelePresence System Codec C20
Contents Introduction
SystemUnit configuration
xConfiguration SystemUnit Name
Enter a System Name to define a name of the system unit. If the H.323 Alias ID is configured on the
system then this ID will be used instead of the system name. The system name will be displayed:
1) When the codec is acting as an SNMP Agent.
2) Towards a DHCP server.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: xConfiguration SystemUnit Name: "Meeting Room"
xConfiguration SystemUnit MenuLanguage
Select the language to be used in the menus on screen, or on the touch screen control panel. All
languages are not supported on both user interfaces. The default language is English.
Requires user role: USER
Value space: <English/ChineseSimplified/ChineseTraditional/Catalan/Czech/Danish/Dutch/Finnish/
French/German/Hungarian/Italian/Japanese/Korean/Norwegian/Polish/PortugueseBrazilian/Russian/
Spanish/SpanishLatin/Swedish/Turkish/Arabic/Hebrew>
Example: xConfiguration SystemUnit MenuLanguage: English
xConfiguration SystemUnit CallLogging Mode
Set the call logging mode for calls that are received or placed by the system. The call logs may then
be viewed via the web interface or using the xHistory command.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable logging.
On: Enable logging.
Example: xConfiguration SystemUnit CallLogging Mode: On
Codec C20 API Reference Guide TC7.0, JANUARY 2014.
D14869.11
About the API xConfiguration xConfiguration
xConfiguration SystemUnit ContactInfo Type
xConfiguration SystemUnit IrSensor
59
xCommand
Choose which type of contact information to show in the status field in the upper left corner of the
main display and touch screen control panel. The information can also be read with the command
xStatus SystemUnit ContactInfo.
Requires user role: ADMIN
Value space: <Auto/None/IPv4/IPv6/H323Id/E164Alias/H320Number/SipUri/SystemName/
DisplayName>
Auto: Show the address which another system can dial to reach this system. The address depends
on the default call protocol and system registration.
None: Do not show any contact information in the status field.
IPv4: Show the IPv4 address as contact information.
IPv6: Show the IPv6 address as contact information.
H323Id: Show the H.323 ID as contact information (see the H323 Profile [1..1] H323Alias ID
setting).
E164Alias: Show the H.323 E164 Alias as contact information (see the H323 Profile [1..1] H323Alias
E164 setting).
H320Number: Show the H.320 number as contact information (only applicable if connected to a
Cisco TelePresence ISDN Link gateway).
SipUri: Show the SIP URI as contact information (see the SIP Profile [1..1] URI setting).
SystemName: Show the system name as contact information (see the SystemUnit Name setting).
DisplayName: Show the display name as contact information (see the SIP Profile [1..1] DisplayName
setting).
Example: xConfiguration SystemUnit ContactInfo Type: Auto
Both the Codec C Series and PrecisionHD camera have IR sensors, and only one of them needs to
be enabled at the time. The IR sensor LED is located on the front of the codec and the camera and
flickers when an IR signal is received from the remote control.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at camera is
enabled. Otherwise, the IR sensor on the codec will be enabled.
Off: Disable the IR sensor on the codec.
On: Enable the IR sensor on the codec.
Example: xConfiguration SystemUnit IrSensor: Auto
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.