Cisco TelePresence System Codec C20 Reference Manual page 102

Cisco TelePresence System Codec C20
Contents Introduction
xCommand Phonebook ContactMethod Modify
Modify details about the contact method for an existing contact in the local phonebook.
ContactId: The unique identifier for the contact. The identifier will be returned by an xCommand
Phonebook Search command. It was also returned when the xCommand Phonebook Contact Add
command was issued to make the contact.
ContactMethodId: The unique identifier for the contact method you want to modify. The identifier
will be returned by an xCommand Phonebook Search command. It was also returned when the
xCommand Phonebook ContactMethod Add or xCommand Phonebook Contact Add commands
were issued to make the contact method.
Device: Set which type of device to call to.
Number: The phone number or address of the contact.
Protocol: Select Auto, SIP, H323 or H320 protocol.
CallRate: Set a call rate.
CallType: Select a call type (audio or video).
Requires user role: USER
Parameters:
ContactId(r): <S: 0, 255>
ContactMethodId(r): <S: 0, 255>
Device: <Mobile/Other/Telephone/Video>
Number: <S: 0, 255>
Protocol: <Auto, H320/H323/SIP>
CallRate: <0..6000>
CallType: <Audio/Video>
Example:
xCommand Phonebook ContactMethod Modify ContactMethodId:117
ContactId:localContactId-10 Number:"newnumber@cisco.com"
OK
Codec C20 API Reference Guide TC7.0, JANUARY 2014.
D14869.11
About the API xConfiguration
xCommand Phonebook ContactMethod Delete
102
xCommand xCommand
Delete a contact method from an existing contact in the local phonebook.
ContactId: The unique identifier for the contact you want to change. The identifier will be returned
by an xCommand Phonebook Search command. It was also returned when the xCommand
Phonebook Contact Add command was issued to make the contact.
ContactMethodId: The unique identifier for the contact method you want to delete. The identifier
will be returned by an xCommand Phonebook Search command. It was also returned when the
xCommand Phonebook ContactMethod Add command was issued to make the contact method.
Requires user role: USER
Parameters:
ContactId(r): <S: 0, 255>
ContactMethodId(r): <S: 0, 255>
Example:
xCommand Phonebook ContactMethod Delete ContactId:localContactId-2
ContactMethodId:1
OK
*r PhonebookContactMethodDeleteResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.