Cisco TelePresence System Codec C20 Reference Manual page 181

Cisco TelePresence System Codec C20
Contents Introduction
xStatus Video Input DVI [2] SignalState
Shows the signal state for the DVI-I input.
Unknown: The signal format is unknown.
OK: A signal is detected and the signal format is supported.
Unsupported: A signal is detected, but the signal format is not supported.
Value space of the result returned:
<Unknown/OK/Unsupported>
Example:
xStatus Video Input DVI 2 SignalState
*s Video Input DVI 2 SignalState: OK
** end
xStatus Video Input USB 3 Type
Not in use in this software version.
Value space of the result returned:
<Camera/Composite/DVI/HDMI/HD-SDI/USB/YC/YPbPr/VGA/Unknown>
xStatus Video Output
Shows the top level overview of the video output status.
xStatus Video Output HDMI [n] MonitorRole
Describes which video stream is shown on the monitor connected to the video output HDMI
connector.
First/Second/Third/Fourth: The role of the monitor in a multi-monitor setup. In a singlemonitor setup,
there is no difference between First, Second, Third and Fourth.
PresentationOnly: Shows presentation video stream if active.
Recorder: Shows all participants, including the local main video. If active, shows also the
presentation.
InternalSetup: Determined by the system, when xConfiguration Video Output HDMI [n] MonitorRole
is set to Auto.
Value space of the result returned:
<First/ Second/ Third/ Fourth/ PresentationOnly/ Recorder/ InternalSetup>
Example:
xStatus Video Output HDMI 1 MonitorRole
*s Video Output HDMI 1 MonitorRole: First
** end
Codec C20 API Reference Guide TC7.0, JANUARY 2014.
D14869.11
About the API xConfiguration
xStatus Video Output HDMI [1, 2] Resolution Height
xStatus Video Output HDMI [1, 2] Resolution Width
xStatus Video Output HDMI [1, 2] Resolution RefreshRate
181
xCommand
Shows the resolution height (in pixels) for the video output HDMI.
Value space of the result returned:
<120..3000>
Example:
xStatus Video Output HDMI 1 Resolution Height
*s Video Output HDMI 1 Resolution Height: 720
** end
Shows the resolution width (in pixels) for the video output HDMI.
Value space of the result returned:
<176..4000>
Example:
xStatus Video Output HDMI 1 Resolution Width
*s Video Output HDMI 1 Resolution Width: 1280
** end
Shows the resolution refresh rate (Hz) for the video output HDMI.
Value space of the result returned:
<1..300>
Example:
xStatus Video Output HDMI 1 Resolution RefreshRate
*s Video Output HDMI 1 Resolution RefreshRate: 60
** end
API Reference Guide
xStatus xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.